Digital Hygrometer

TDI's Digital Hygrometer is a precision electronic instrument that measures relative humidity and temperature in desiccators and glove boxes. (A hygrometer is not required when the Nitro-Save option is chosen).

Model: #715H for Clear Acrylic and #715HSD for Static Dissipative Acrylic

Range: Humidity: 10% to 99% RH
Range: Temperature: 50 to 70 C (-58 to 158 F)

Accuracy: Humidity: +/- 5% RH
Accuracy: Temperature: +/- 1 C (1.8 F)

Battery: AG10

mig-6c5f7b3d2acaf1ad.jpg

Start Up

The unit will begin to function automatically once the battery insulating tape is pulled off.

Maximum Humidity and Temperature Recording

  1. The MAX/MIN humidity and temperature is recorded automatically.
  2. Press MAX/MIN button to read the MAX/MIN humidity and temperature since the last time the CLEAR button has been pressed. The respective MAX or MIN indicator will be displayed.
  3. Hold CLEAR button for 2 seconds to reset memory of MAX/MIN reading.

C / F Slider Switch

Selects between Celsius (C) or Fahrenheit (F) temperature unit display.

Battery Replacement

Slide open the built-in compartment and replace the exhausted battery with a new 1.5V AG10 battery according to the polarity shown. The unit will resume working in a few seconds.

Caution

  • Do not subject the unit to water, AC power, or extreme weather conditions. Operate the unit within -50 C to 50 C, 10% to 99% RH.
  • If the humidity area of the display shows a dash percent sign, the measured temperature is lower than -50 C or higher than 60 C, or the measured humidity is lower than 10%. We do not recommend using the unit in these extreme conditions. When ambient conditions return to the normal operating range, the humidity display will show the correct reading again.
  • Do not attempt to dismantle the unit's internal components.
  • Do not insert a used battery or any battery type other than AG10. Dispose of used batteries properly with environmental care, as they are harmful.

TDI desiccator cabinets require a continuous in-line nitrogen (N2) or clean dry air (CDA) source. The N2/CDA goes in through the flowmeter to the plenum chamber. The gas then flows evenly into and between the chambers via our Ultra Nitro-Flow system. The excess N2/CDA automatically bleeds off via the bleeder valve at the bottom of the cabinet. TDI desiccators do not require and are not compatible with desiccants or any other type of drying agent.

Shop desiccator cabinets