KD Tweezers, Quality Assurance Class 0 CDM Test Procedures

mig-c0fca26b0272ad72.gif
  • TDI meets all of the criteria for ESD testing, as proposed by IDEMA.
  • We perform all of these testing procedures internally, including the especially critical Transient Current Discharge testing.

Point-to-Point Resistance

  • Resistance between tip top and bottom (tip without handle)
  • Resistance between handle and one tip at a time
  • Surface resistance 100% inspection
  • Automatic pass/fail signal

Acceptance Limits:

  • Low resistance limit: 1 x 10^6 Ohm, high resistance limit: 1 x 10^8 Ohm for 50 and 100V
  • Low resistance limit: 1 x 10^7 Ohm, high resistance limit: 1 x 10^9 Ohm for 10V

Static Decay Analysis

The time to discharge a 20pf isolated metal plate previously charged to 1000 volts to less than 10 volts is measured. During the 1000 volt discharge, sparks should not be observed. The decay curves should have a correct exponential course. The acceptance limits are defined as follows:

  • Residual voltage less than 3 volts
  • Decay time less than 500 milliseconds

Triboelectric Charge Determination

The purpose of this discharge test is to measure any residual charges on the tweezers following normal procedures as shown. The acceptance limits are defined as follows:

  • Residual voltage less than 3 volts

Transient Current Discharge Analysis

MR circuits utilized in disk drive assemblies are highly static sensitive in both current and voltage ESD discharge environments. TDI developed the "KD" ceramic tweezers to provide the lowest discharge parameters, as measured by transient current discharge procedures defined by the disk drive industry. TDI meets the critical transient current discharge parameters for each disk drive customer's specifications. The Direct Charged Device Model (DCDM) was chosen as the methodology to determine the transient peak current. This occurs during the discharge of a charged object through a dissipative tip tweezers.

Transient Current Determination MethodologyTest Procedure

High Precision Static Dissipative KD Ceramic Replaceable Tip Tweezers

TDI pioneered the "KD" static dissipative ceramic tweezers for the most critical ESD applications, with excellent transient current discharge performance: less than 40V ESD threshold, Class 0 CDM compliant.

High precision ceramic tip tweezers provide the features of enhanced strength as well as a high surface finish ceramic tip material. These tweezers feature alignable replacement tips, saving you money as opposed to purchasing new tweezers. The handles are made of the highest quality anti-magnetic stainless steel. Considered an excellent choice for ultra high temperature applications as well as handling of sensitive ceramic and glass parts, especially in applications where nonmetallic scratching is critical.

For more information on ESD standards, please visit: ESD Association

mig-07df5a5fa3408b5c.gif
mig-d7752cfc2e8cc5ec.gif
mig-f8496fec6ed9cdbf.gif
mig-4cf51c59a3b626ed.gif
mig-c9b742b721b77b2f.gif
mig-924e62e5268d6374.gif
mig-784d88ee971520cc.gif
mig-b00df8f2f0f1c132.gif
Shop Tweezers